Damp Check Kit provides an effective moisture barrier when isolating damp walls from internal finishes. The air gap behind the damp-proof membrane allows walls to breathe and water to drain. 10m Kit

Helical wall ties in a 30 square metre kit, based on spacing’s of 2.5 ties per square metre. European CE Mark Approval to EN845-1:2013. Includes 75 brick ties, SDS drill bit and SDS drive tool

Retrofit bed joint rein­for­cement pack containing 6mm x 7m stainless steel helical bars. The 6mm reinforcing bar is the standard size rod used for most masonry repair appli­cations. Pack of 5

5mm-9mm Diameters- 10 Pk
Twistfix brick rein­for­cement stitching bars are used to reinforce and strengthen fractured brick and masonry walls. Reinforcing bars are 1m long.

Insulation fasteners for fixing ply-faced Celotex or Kingspan decking boards. Hammer in fixings for flat warm roof deck insulation upto 210mm deep. Rust resistant Stainless Steel - 20 Pk or 400 Box

Helical ties in a 20 square metres kit, based on spacing’s of 2.5 ties per m2. European CE Mark Approval to EN845-1:2013. Includes 50 ties, SDS tungsten carbide drill bit and SDS setting tool

Easy to use DIY damp proofing kit. Includes everything you need to provide an effective damp proof course in walls. This kit treats up to 30m of single leaf walls or 15m of double leaf brickwork.

Waterproof membrane for tanking walls and floors. Cavity drain membranes in 40m2 & 48m2 rolls for basement water­pro­ofing. Leaves surfaces ready for dry wall lining or floor screeds. Sizes: 2 x 20m or 2 x 2.4m

A cost effective high density polyethylene tanking membrane with 3mm studs formed on one face of the product and a mesh welded to the other side. Available at a special trade price in a 1m x 20m or 2m x 20m roll